-={ SAMDROID TURBO }=-

**Maciej_27** · 06-20-2010, 11:14 PM

Locking button does not work

**antibyte** · 06-20-2010, 11:15 PM

Originally Posted by Maciej_27

Locking button does not work

Redownload and reinstall the library package.
The first one had a wrong file in it.

**zooommm** · 06-20-2010, 11:26 PM

V7
I think is slower.
JIT will not run, phone will not boot.
"Speedx 3D has" every few seconds funny pictures jerkiness.
Linpack Score 5.2

Irgendwo ist da beim "3D" Treiber nen Bug, antibyte ich glaube du kannst ja Deutsch, bei fragen einfach PN

**HTD** · 06-20-2010, 11:29 PM

Here

**GRaven** · 06-20-2010, 11:33 PM

FPS2D : 56AVG
Gears : 20-21FPS but looks worse
Linpack : 4.8 - 5.2

**Fulkerson** · 06-20-2010, 11:35 PM

Originally Posted by antibyte

[*]Compiling drivers for architecture "armv5te" seems to increase gfx speed, wtf ?

It doesn't have something with this to do?

-mtune=name
This option is very similar to the -mcpu= option, except that instead of specifying the actual target processor type, and hence restricting which instructions can be used, it specifies that GCC should tune the performance of the code as if the target were of the type specified in this option, but still choosing the instructions that it will generate based on the cpu specified by a -mcpu= option. For some ARM implementations better performance can be obtained by using this option.

I've read through it a few times now and I can seriously not understand what they actually mean. If I'm correct it'll tune code for one type using instructions for another?

Also, no need to use odin for flashing. "bml_flash boot zImage" from shell works perfectly

No need to be afraid of loss of power or the usb cable popping out.

**antibyte** · 06-20-2010, 11:35 PM

Originally Posted by GRaven

FPS2D : 56AVG
Gears : 20-21FPS but looks worse
Linpack : 4.8 - 5.2

My top one in Linpack was 5.302 and 23 FPS in Gears amd 264 in Quadrant

Did you try with kernel or only the Libs+DVM ?

**AlexVortex** · 06-20-2010, 11:38 PM

спасибо,полет нормальный!

**antibyte** · 06-20-2010, 11:42 PM

Originally Posted by zooommm

V7
I think is slower.
JIT will not run, phone will not boot.
"Speedx 3D has" every few seconds funny pictures jerkiness.
Linpack Score 5.2

Irgendwo ist da beim "3D" Treiber nen Bug, antibyte ich glaube du kannst ja Deutsch, bei fragen einfach PN

I did not test JIT as i thinh its not really useable at all.
But i will try to build a 20MFlops special version

Did you install all JIT files ? This version has debugging disabled,
so you need to install ibdvm.so+nativehelper.so+dalvikvm !
You cant mix files her i think.

As for games i tested only raging thunder 1, and that works
without problems.

Und ja, ich spreche auch Deutsch

**SOLOVEY** · 06-20-2010, 11:43 PM

После первой установки (через рекавери), я
прождал 7 минут на загрузке, но система не
запустилась. Дальше было еще две таких же
попытки. Тогда я сделал wipe>data/cashe, система
загрузилась за 53.7сек. и 2.1минута Конечно я совершенно не виню автора мода, в длительной загрузке системы, скорее всего я сам довел ее до такого. Еще раз спасибо.
Буду тестировать обновку

--------------
After the first installation (through recovery), I
have waited for 7 minutes on loading, but the
system was not started. There were two more same
attempts further. Then I have made wipe> data/cashe, the system was loaded for 53.7 sec. &.2.1min.
I am final at all I do not blame the author
a fashion, for long loading of system, most likely I have finished it to the such.
Once again thanks. I will test a new thing

------------
A bit later...
Samsung Device Test has shown=
FPS: 7.19
Time:4533ms

Was earlier, maximum 6.5 FPS